Hi Guys,
So I started building my bn2T Henschel model from Modelik a few days back.
The whole chassis has come out real clean and I have also started placing the rivets as well.
Some of you might be of the opinion that I picked a rather complicated model to be my second project, but I think I am doing pretty good except mentioned below.
I am having serious problem making the wheels. I have not got laser cut wheels, so I am making them using NT Circle Cutter.
The circle cuts are very fine, but the model needs concentric circle rings. I am really disappointed because each time I fail to find the center of the circle, and I have spoiled my wheel sheet.
Any ideas/tricks are most welcome. I am in real deep trouble here.
Thanks a lot guys!
Parth
So I started building my bn2T Henschel model from Modelik a few days back.
The whole chassis has come out real clean and I have also started placing the rivets as well.
Some of you might be of the opinion that I picked a rather complicated model to be my second project, but I think I am doing pretty good except mentioned below.
I am having serious problem making the wheels. I have not got laser cut wheels, so I am making them using NT Circle Cutter.
The circle cuts are very fine, but the model needs concentric circle rings. I am really disappointed because each time I fail to find the center of the circle, and I have spoiled my wheel sheet.
Any ideas/tricks are most welcome. I am in real deep trouble here.
Thanks a lot guys!
Parth
Aucun commentaire:
Enregistrer un commentaire