Ken's Apollo CM

So, now I can start the building report after the end of our content.
The story is known, so I don't need to tell the prehistory.

First I made up my mind the heat shield.
The variant without glue flaps is not good. So I printed in gray again everything on thin paper (100g).
Also all over again in black for the inside ...
Outwardly, I realized that the rings did not fit properly so. Had to re-dyeing something.
Ken has apparently corrected by overpaint. Well.
That's why I all over again printed and pasted over and now it fits fairly well.
3x 250 g give a decent strength, too.
Actually, that was just a test build, but it looks quite good, so I'll leave it.
A Frisby disc can still be ....: thumbup:
To shoot down there is the inner ring on the heat shield ...




Next, here's the back division. Here actually fit quite well.
I raised three printouts, one original, one thin paper for adhesive flaps, once black interior.
Everything together is a fairly stable structure.
The salad bowl suits well to the Frisbie disc.
Now it comes to the decoration of the bowl.

Attached Images

	DSC02591.JPG (175.1 KB)
	DSC02592.JPG (143.7 KB)
	DSC02593.JPG (225.1 KB)
	DSC02594.jpg (262.2 KB)
	DSC02595.JPG (226.3 KB)
	DSC02596.JPG (177.9 KB)
	DSC02597.JPG (184.9 KB)
	DSC02607.JPG (209.1 KB)
	DSC02612.JPG (158.5 KB)
	DSC02611.JPG (236.8 KB)
	DSC02614.jpg (242.9 KB)
	DSC02615.JPG (207.6 KB)
	DSC02617.JPG (193.3 KB)
	DSC02621.jpg (267.4 KB)
	DSC02622.JPG (218.7 KB)
	DSC02623.jpg (265.0 KB)
	DSC02624.JPG (214.2 KB)
	DSC02627.JPG (178.1 KB)
	DSC02628.JPG (196.9 KB)
	DSC02629.JPG (185.0 KB)