Hello all,
It's been a while since i posted something here, but I'm started on the Apollo Saturn 5 project again.
The biggest problem i do face is the limitation of the paper size, both A4 and Letter.
Since i only have a A4 printer i was looking for a workaround to this limitation.
I found out (probably a lot of you people out there found the same solution :)) that my printer, a Cannon MG5350 allows the setting of a longer paper size as long it is not wider then A4.
So i took a part of the Saturn 5 Main body and made a drawing of 210 mm high and 680 mm wide and printed that.
The result is shown in the PDF attachment.
Does anyone else did experiment with those printer settings in this way ?
I'm looking forward to your suggestions and comments.
Greelt
It's been a while since i posted something here, but I'm started on the Apollo Saturn 5 project again.
The biggest problem i do face is the limitation of the paper size, both A4 and Letter.
Since i only have a A4 printer i was looking for a workaround to this limitation.
I found out (probably a lot of you people out there found the same solution :)) that my printer, a Cannon MG5350 allows the setting of a longer paper size as long it is not wider then A4.
So i took a part of the Saturn 5 Main body and made a drawing of 210 mm high and 680 mm wide and printed that.
The result is shown in the PDF attachment.
Does anyone else did experiment with those printer settings in this way ?
I'm looking forward to your suggestions and comments.
Greelt
Aucun commentaire:
Enregistrer un commentaire