This is pretty much a rookie question, but how I can accurately cut the parts from the paper? I have a metal ruler, good scalper, but since the lines that define parts are little bit thicker, I can't assemble them very accurately at the end. It is especially visible at the long and thin parts (e.g. truck frame), where half of millimeter makes a big difference. I just started with GPM Opel Blitz 1:25.
The same question goes for scoring. The lines that define where the parts need to be scored are little bit thicker, and thus it is hard to determine the right spot to do scoring. At the end, it produces not so nice results, because the scoring is sometimes made just in the middle of the line, and sometimes at the very left or right side of it.
The same question goes for scoring. The lines that define where the parts need to be scored are little bit thicker, and thus it is hard to determine the right spot to do scoring. At the end, it produces not so nice results, because the scoring is sometimes made just in the middle of the line, and sometimes at the very left or right side of it.
Aucun commentaire:
Enregistrer un commentaire