Guys,
I've built three ship models out of paper, but always get frustrated with small diameter tubes (less than say 5mm dia.). Masts are especially difficult.
I usually wrap the part around an appropriately sized micro drill shank, secure along the join with tape and then fill the inside with pva. Pre-curving by rolling over the flat part with a drill shank helps, but the paper often splits when rolled, making consistent results difficult. Multiple pieces of small diameter parts are...tedious.
Does anyone have any tips for this kind of work?
Thanks.
I've built three ship models out of paper, but always get frustrated with small diameter tubes (less than say 5mm dia.). Masts are especially difficult.
I usually wrap the part around an appropriately sized micro drill shank, secure along the join with tape and then fill the inside with pva. Pre-curving by rolling over the flat part with a drill shank helps, but the paper often splits when rolled, making consistent results difficult. Multiple pieces of small diameter parts are...tedious.
Does anyone have any tips for this kind of work?
Thanks.
Aucun commentaire:
Enregistrer un commentaire