Here is a finished model of a World of Warcraft tiger.
It can be found here.
I printed it on 12 x 18 inch paper at 150%. It is around 21 inches/53.4 cm long from tip of tail to tip of nose and around 9 inches/23 cm tall at the front shoulder.
There are a bunch of textures included in the downloaded .rar file so you can change the appearance of the figure.
I had posted a picture in the Lounge about how at a point in the build it reminded me of something from John Carpenter's The Thing. Turned out the build sequence should not have followed that path. It looks lik you need to build the hind section with the rear legs and the head section with the front legs then join them using a modified part on page 9 of the model file, part Geoset_0-30. That will leave you access to the inside of the model so you can glue the tabs on the rear and front sub-assemblies to the middle joining part.
I am going to try that out when I build the model with the snow leopard looking texture. One-o'-these-days.:)
It can be found here.
I printed it on 12 x 18 inch paper at 150%. It is around 21 inches/53.4 cm long from tip of tail to tip of nose and around 9 inches/23 cm tall at the front shoulder.
There are a bunch of textures included in the downloaded .rar file so you can change the appearance of the figure.
I had posted a picture in the Lounge about how at a point in the build it reminded me of something from John Carpenter's The Thing. Turned out the build sequence should not have followed that path. It looks lik you need to build the hind section with the rear legs and the head section with the front legs then join them using a modified part on page 9 of the model file, part Geoset_0-30. That will leave you access to the inside of the model so you can glue the tabs on the rear and front sub-assemblies to the middle joining part.
I am going to try that out when I build the model with the snow leopard looking texture. One-o'-these-days.:)
Aucun commentaire:
Enregistrer un commentaire