I don't print much these days. Years ago when I did I was usually fine leaving 1/4 of an inch, maybe 3/8, for each margin, top and bottom. So I figured leaving 1/2 inch for my zeppelin was generous.
Much to my surprise when I went to print out parts I discovered that my printer has a minimum 5/8 margin all the way around. There isn't any way to adjust it that I can find.
Is this typical these days or is it this particular printer (HP Photosmart 6520)?
Should I always design with a 3/4 top and bottom margin just to be safe?
Thanks,
--jeff
Much to my surprise when I went to print out parts I discovered that my printer has a minimum 5/8 margin all the way around. There isn't any way to adjust it that I can find.
Is this typical these days or is it this particular printer (HP Photosmart 6520)?
Should I always design with a 3/4 top and bottom margin just to be safe?
Thanks,
--jeff
Aucun commentaire:
Enregistrer un commentaire