Anyone build this? The tiny one I built for a coworker seemed to disappoint, so I decided to take on the big one - but without instructions, I'm not sure how the interior skeleton parts are supposed to go together. The curved dish frames are pretty obvious, but these parts have me scratching my head:
Attachment 335185
The pieces on the bottom right appear to go in the nacelles, but the lower left and top I'm unsure of. The very top two are reminiscent of the pieces at the notches at the rear of the disk, but as these are laminated to 1 mm card, I'm not seeing how they are supposed to be used.
For anyone else considering this model, my biggest lesson learned so far: the dish quadrants should be laminated to a single large piece of 3mm foam core, not 4 separate pieces. I have also assumed that the underside 4 quadrants laminated to 1 mm should also be a single piece - although I didn't have a piece that large so mine are separate - and then laminated to the reverse of the 3 mm foam core to make a single slab.
Attachment 335185
The pieces on the bottom right appear to go in the nacelles, but the lower left and top I'm unsure of. The very top two are reminiscent of the pieces at the notches at the rear of the disk, but as these are laminated to 1 mm card, I'm not seeing how they are supposed to be used.
For anyone else considering this model, my biggest lesson learned so far: the dish quadrants should be laminated to a single large piece of 3mm foam core, not 4 separate pieces. I have also assumed that the underside 4 quadrants laminated to 1 mm should also be a single piece - although I didn't have a piece that large so mine are separate - and then laminated to the reverse of the 3 mm foam core to make a single slab.
Aucun commentaire:
Enregistrer un commentaire